No more 3M Masking tape
No more glue stic
No more ABS juice
No more PEI sheet replacement
Easy to print
Easy to remove by bending and popping it off
Easy to maintain
Lower runing cost especially for printing farm
Genuine PEI powder coating
Hardened steel spring sheet never diforming
Make adding inductive Z-probe possible
Possible to adding ABL for some low-cost printers
PLA ABS PETG TPU PVA etc.
241x252MM 9.5"x10" (for prusa i3 mk2.5s / mk3 / mk3s)
The following dimensions are still in development
Pulse printer with FlexPlate installation
Similar bed size printer with Magnetic Base.
Wipe the print surface before and after a print with isopropyl alcohol to maintain a clean surface for maximum bed adhesion strength. As with any build surface, make sure you are not printing too close to the bed to avoid possibly infusing the filament into the build surface. If printing PETG, TPU, TPE, and RYNO, make sure the bed is heated BEFORE attempting to remove the print from the bed.
It is possible to mount our kits on a larger bed, just be aware that you will have a reduced printing area. It is also possible to mount our kits on slightly smaller beds; you can carefully trim the Magnetic Base, but the Flexi Plate will stick over your edges, be sure that there are no obstructions such as vertical frame elements, and it is advisable not to have more than 10mms overhang per side to avoid warping. we are not responsible for mistaken order sizes.